Shoulder ANF leather stamp

Shoulder Patch Leather Stamp – Australia

Designed as an accessible, practical alternative to traditional brass stamps, this shoulder patch leather stamp is ideal for short-run and repeat use where precision and consistency matter without the cost or lead time of metal tooling.

Sized specifically for Australian shoulder patches, the stamp features a 3 mm solid base with 1 mm raised elements to produce a clean, readable impression. A 5 mm internal border is built into the design to allow for stitching without the need to cut stitch lines by hand.

Printed in PETG-CF for improved strength and heat resistance, each stamp is tested under a 4-ton arbor press on wetted 3 mm vegetable-tanned leather. In most cases, stamps comfortably exceed eight presses, with minor border warping only occurring after extended use.

This stamp is intended as a reliable, easy-to-use option for makers who want repeatable results without committing to permanent brass tooling.

Specifications

• Dimensions: 75 mm × 60 mm × 4 mm
• Material: PETG-CF
• Raised detail height: 1 mm
• Integrated stitch border: 5 mm from edge

Tested Use & Guarantee

Each stamp is guaranteed for up to 8 presses when used as recommended. While many stamps exceed this in testing, minor warping can occur beyond this point depending on pressure, leather type, and moisture content.

If the stamp fails to perform within the guaranteed range under appropriate use, a refund or replacement will be provided.

Recommended Use

• Wet 3 mm vegetable-tanned leather
• Arbor press (up to 4 ton)
• Short-run production and repeat stamping
• Not intended for hammering or dry leather use